• Camera Feed Camera Feed at

    Looking north towards Traralgon and northeast toward Loy Yang and Flynns Creek., located: Callignee, Victoria 3844

  • Site Camera Feed at

  • Site Camera Feed at

  • data over the last 48 hours in table format

    Data not available

  • Where does this data come from?

    EPA has monitoring sites in population centres around Victoria.

    Most of our air monitoring sites are next to roads. This is because most Victorians live and work close to roads.

    EPA and VICSES can also deploy equipment to monitor air quality nearby an incident like a fire.

    We also collect data from a citizen science project. The Inner Melbourne Air Monitoring project sees citizen scientists working with us to help build an understanding of air pollution impacts.

    The air quality where you are might be different to what you see on EPA AirWatch, even if there’s a monitoring site close to you. This is because there are many factors that can affect air quality. For example, wind direction and smoke from wood fires.

Google Map Pins.

Google Map

Air quality 
around Victoria

This interactive map lets you see air quality around Victoria. To find out more about our air quality categories, click here.

Note that Kingsville, Newport and Spotswood are temporary air monitoring sites that are part of a citizen science project.

Since 22 July, EPA's equipment near the Stevensons Brothers Industries (SBI) landfill in Ballarto Rd, Cranbourne, has been monitoring hydrogen sulphide in the air every 5 minutes. The graph below shows the results from 22 to 26 July.

EPA has analysed these results. We found most hydrogen sulphide concentrations were either unable to be measured because they were too low or they were at 0.0 parts per million (ppm). On 23 July 2022, there was one result of 0.2 ppm measured within a 5 minute period. These levels are not expected to cause long term adverse health effects.

For more information, visit SBI landfill.

Types of monitoring sites

  • Standard monitoring sites

  • Incident monitoring sites

  • Sensor/camera monitoring sites

  • Good
  • Fair
  • Poor
  • Very poor
  • Extremely poor
  • No Data
View data in table format

More details

  • Disclaimer

    Data on EPA AirWatch comes directly from our air monitoring stations using various types of monitoring equipment and methods. This data may be adjusted later according to set criteria to account for instrument errors, power interruptions and other technical issues.

    EPA aims to locate our ambient monitoring stations so they give a good representation of the air quality experienced by the public. As most of the Victorian population lives and works close to roads, most of our stations are in population centres next to roads. This can mean we do not always comply with one of the requirements of the Australian Standard for siting (AS 3580.1.1), which specifies that air monitoring stations should be more than 50 metres away from a road. Currently, Footscray is the only EPA air monitoring site that meets this requirement.

    Read more about our National Association of Testing Authorities (NATA) accreditation.

  • Check the air monitoring network status

    Alphington: Monitoring for PM2.5 site is offline due to routine maintenance and no PM2.5 data is being collected at this station. EPA expects data to become available on the website from 5pm, 28/11/2022. The air quality forecast for Melbourne is expected to be GOOD. (24 November 2022)

    Morwell East air monitoring site is offline due to technical difficulties and no PM10 and PM2.5 data is being collected at this site. Our technicians are working to fix the problem. (23 November 2022)

    Mildura air monitoring site is offline due to technical difficulties and no PM10 and PM2.5 data is being collected at this site. Our technicians are working to fix the problem. (25 November 2022)

  • Connect to our developer portal

    Are you a developer looking to connect to our application program interface (API)?

    Our developer portal lets developers explore the APIs published by EPA Victoria. Just sign up, subscribe to a product and you are all set to access the APIs associated with that product!

    Connect to our developer portal.

  • Access historic data

    Historical hourly air quality data is available at data.vic.gov.au. Files for each year are uploaded once data validation is complete.  To request data not yet available on data.vic.gov.au, please contact EPA with the details of your request.